The air temperature can be adjusted to suit a wide range of applications. The table below suggests
settings for different applications.
Setting
Applications
Ⅰ
Drying and curing paint, varnish color shade samples, filler, adhesives,
construction joints and stucco forms
Drying wet timber prior to filling
Removing stickers
Joining adhesives-Large-surface gluing with contact adhesives, activation of
pressure-sensitive adhesives, acceleration of bonding processes, releasing of
bonding points as well as releasing or bonding of edge band or veneer
Waxing and de-waxing
Shrinking PVC wrapping and insulation tubes
Defrosting of icy stairs and steps, door locks, trunk lids, car doors or water pipes,
as well as for defrosting refrigerators and ice boxes
Ⅱ
Welding of thermoplastic polymer, flooring materials of PVC and linoleum,
PVC-coated fabric, tarpaulins and foils
Bending plastic pipes and sheets
Soldering plumbing joints, tin, special silver solder, SMD elements, cable lugs
Loosening rusted or tightly fastened nuts and bolts
Removing old and even thick coatings of oil paint , lacquer, varnish and synthetic
plaster
Disinfection and sterilization
If you are not sure about the correct setting, start with a low temperature setting
and gradually increase the temperature until you achieve optimum results
8
INSTRUCTIONS FOR USE
Always observe the safety instructions and applicable regulations.
Use only one hand to hold the tool; do not place your other hand over the air vents.
Prior to operation set the desired air temperature.
8.1
Switching on and off
To switch the tool on, set the on/off switch to position
Ⅰ
/
Ⅱ
.
Some smoke from production residue may be emitted after switching on; this does not indicate
a problem.
To switch the tool off, adjust to the lowest temperature to cool off, then set the on/off switch to
position 0. Let the tool cool down before moving or storing it.
8.2
Temperature setting.
Turn ON/OFF switch to
Ⅰ
/
Ⅱ
, depending on temperature you need. The heat gun will start to heat.
You can increase or decrease the outlet temperature gradually by turning the adjust knob.
Turn counter-clock wise to increase, clock wise to decrease the temperature.
