DuraTech Industries HAYBUSTER H-800, Инструкция по эксплуатации и справочник по запасным частям

Страница: 37 / 132

27
H - 8 0 0 T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
GRINDING
Place materials to be ground directly into the tub. The best method for filling the H-800 Tub Grinder is:
1. Engage rotor and increase engine speed to 1000 RPM on the P.T.O. shaft.
2. Fill the tub about half full of unground materials before starting tub rotation.
3. Start tub.
4. Place additional materials in the tub.
LOOSE HAY
The best capacity will be obtained if the tub is consistently kept no less than half full of loose hay. When loading
the tub, place materials slightly to the rear rather than directly over the rotor. For best results feed the tub with small
portions.
WET OR FROZEN HAY
This is the toughest material for any grinder to handle. When filling the tub with wet or frozen hay, deposit small
quantities on a more frequent basis rather than filling the tub with one load.
LARGE ROUND BALES
Place large round bales in the tub on end.
IMPORTANT: Never drop a large round bale into the tub from a high level. Ease the bale over the
edge and down into the tub carefully. Dropping a large bale directly on top of the rotor will cause
damage to the rotor.
CROP RESIDUE
When grinding crop residues, use the same methods as with loose hay. Extremely wet or frozen materials should be
placed sparingly into the tub.
SMALL GRAINS
Grinding small grains requires special attachments. These attachments fit directly over the rotor. It is not
recommended that small grains be ground without the use of one of the small grain attachments. (See Appendix B:
H-800 Tub Grinder Specifications under the heading “Options”.)