Instruction Manual
HC-45S SC Cutter - V1.1
www.durapac.com
Page 6 of 10
5.3
After Operation
5.3.1
Clean the product and blades.
6.0
Maintenance
IMPORTANT:
Check oil level regularly and make sure the reservoir is full
Use only good quality hydraulic fluid.
Do NOT
use brake fluid, transmission fluid,
turbine oil, motor oil, alcohol, glycerine etc. Use of anything other than good quality
hydraulic oil will void warranty and damage the cutter. We recommend Durapac
Hydraulic Oil or equivalent
Equipment must only be serviced by a qualified hydraulic technician. For repair service,
contact your local Durapac authorised service centre
Tools with worn or damaged blades may cause property damage or even personal
injury
The hydraulic relief valve pressure should only be adjusted by a Durapac
representative
Maintenance is required when wear or leakage is noticed. Periodically inspect all
components to detect any problem that may require service and maintenance.
Keep the tool head free of dirt and metal chips. Use a lubricant to clean the tool when
necessary.
Routine application of rust preventative oil to the product is needed. Avoid bringing the tool
into contact with water or solvents.
6.1
Blade Replacement
6.1.1
Fixed Blade Replacement
6.1.1.1
Open the tool head and pull back the fixed blade. Remove the four
small screws to unfasten the blade.
6.1.1.2
Position the new blade, reassemble the small screws.
6.1.1.3
Ensure that all components are tight and that the blade opens and
closes smoothly.
6.1.2
Moving Blade Replacement
6.1.2.1
Advance the lower blade until the connecting pin is visible on the
main piston.
6.1.2.2
With the tool head open, remove the connecting pin to unfasten the
blade.
6.1.2.3
Insert the new blade and reassemble the connecting pin to secure
the blade in place.
6.1.2.4
Ensure that all components are tight and the blade moves back and
forth smoothly.
