OK/DEL
It is a key for shared with two functions. Any time you have done to program the WORK, Q-
SHOT and PAUSE / Video Length, just press the OK/DEL key to accept the new change. On
the other hand, press and hold it with 3 seconds, it perform the DELETE function that all event
counts on the lower LCD will be cleared. But it is not effect to any contents in the camera
memory
Event Counter
Three digits in the center of the lower LCD are the event counter which let you know how
many motion records that up to 999 events for a trail history. If you want to renew the counter
anytime, simply to press and hold the OK/DEL button until LCD become blinking, then it will
resume to [000].
Battery Icon
Two icons are for difference battery groups. The Bat-icon on the upper corner of right is repre
-
sented for motion sensor power. The second on the right is for camera power. All Bat-icons will
indicate three status as below:
GOOD: Battery Icon show with solid.
LOW: Battery Icon is half blank.
BAD: Battery icon is totally blank.
Note: You have to replace all batteries in camera section or motion sensor section
for new one completely when either camera or motion power are BAD. Do not try to
replace some of them only. Please note that the motion sensor power is independent
to the camera power system. Mostly, the motion power will last much longer than
IR light power.
Walk-Test / Sensitivity Adjustment
The DISTANCE dial on inner panel is used for adjusting sensitivity of the motion sensor. By
turning the dial to the right, sensor sensitivity is set to the Max to detect animal over 40 feet
away. You may reduce the detection distance for taking picture with a larger animal target.
Walk-Test feature is used to verify the detection range and pointing zone before placing it in the
field. After hanged the unit on a tree, push the PW switch to Walk-TEST.
The Walk-Test LED will light up last 1 minute to warm up. A radar icon with TEST alert is re-
maining blinking during Walk-Test mode. Then, Walk-Test Light will goes off and will alert with
3 times flash once you will be detected in front of the device.
Now you try to go far away to check how long the PIR motion sensor will still see you. The
camera does not take any picture during this test process.
Note:
The system will resume to normal ON DUTY mode automatically after 3 minutes (Time-
Out) since the last triggered detection of walk-test to avoid user may forget to push the PW
switch back to ON before left.
25
Содержание 10029765
Страница 1: ...10029765 Wildkamera ...
