background image

DURAGRAIN  PRIVACY

www.duramaxbp.com

Have Questions?

Call us at 1-800-483-1361

Engineered For The Southwest Sun

TM

Gate  Kit Assembly Instructions

 

Gate Lock and Hinges are not included

PLEASE READ THESE

INSTRUCTIONS

BEFORE ASSEMBLY

During assembly, vinyl components should be 

laid on a non-abrasive surface (i.e. cardboard or 

drop cloth) so as not to scratch.

•  Use care when applying PVC cement, as it 

dries quickly. Vinyl should be cleaned with 

a mild detergent and non-abrasive cleaning 

pad or sponge.

•  Vinyl components should be assembled 

without using excessive force, to avoid 

breakage.

• 

Assemble gate after fence installation, to 

accurately locate hinge and latch post and 

proper width size.

•  Gates should not be made any wider than 

48", to avoid sagging from hinge post.

•  All hinge posts, properly installed, should 

have steel insert and be filled at least 75% 

with concrete.

• 

Cut Top and Bottom rail 2" shorter than 

distance between hinge and latch post.

            For Example: If the gate opening is 44"

            cut Top and Bottom rail to 42".

 

         

        TOOLS NEEDED

 

•    Measuring Tape / Ruler
•   Pencil
• 

  Screw Driver (Phillips #2)

• 

  Drill with �⁄��" bits

•    Drop Cloth
•    Square Level
•    Rubber Mallet

Содержание Duragrain Privacy

Страница 1: ... abrasive cleaning pad or sponge Vinyl components should be assembled without using excessive force to avoid breakage Assemble gate after fence installation to accurately locate hinge and latch post and proper width size Gates should not be made any wider than 48 to avoid sagging from hinge post All hinge posts properly installed should have steel insert and be filled at least 75 with concrete Cut...

Страница 2: ... the Upright Post using 4x Sheet Metal Screw as shown in Figure 2b 2c Completed Upright Posts with the mounted End Channel Figure 2c Pocket Rail Metal Support Step 1 Pocket Rail Metal Support Installation 4 Pieces Included Insert tightly the Metal Pocket Rail support into the empty bottom slot of the Pocket Rails on both end sides of the top and bottom Pocket Rail x4 Figure 1 Figure 1 Metal Pocket...

Страница 3: ...e into the picket as shown in Figure 3c Then do the same procedure for the other side Upright Post Figure 3d Figure 3c Upright Post Picket End Channel Pocket Rail Pocket Rail Figure 3d Use a Square Level for all the corners for proper leveling and alignment before doing Step 4 IMPORTANT Slide the remaining Pickets in between the 2 Pocket Rail grooves and the last Upright Post Figure 3e Figure 3e E...

Страница 4: ...Rail with Sheet Metal Screws Vinyl Screw Cap 32 pcs included 1 Pan Head Sheet Metal Screw 32 pcs included Figure 5b Pre measure and pre drilled all 4 corners of Upright Post on both sides top and bottom for the Sheet Metal Screw Figure 5a 5b Drive the Sheet Metal Screw into the Upright Post in 4 spots Figure 5c then cover the Sheet Metal Screw head with the Vinyl Screw Cap Figure 5d Vinyl Screw Ca...

Отзывы: