FIGURE 4
LIGHTING INSTRUCTIONS WHEN USING MATCH (CONTINUED)
1. Open Cylinder valve by turning
counterclockwise
.
2. Turn heater regulator knob
counterclockwise
to the
“High” position. (Fig. 4)
WARNING:
Stand to the side of unit while
lighting. Do not stand or have any part of your
body over or in front of heater while lighting.
CAUTION:
Do not insert match
into air inlet holes in mixing tube.
WARNING:
Do not push in safety shut-off
valve plunger before inserting lit match.
3. do not attempt to light one burner off of
the other. use one match per burner.
locate ignition hole in side of burner.
(Fig. 5) Insert a lit match through ignition hole.
FIGURE 5
10
PROPANE TANK TOP HEATER
TT15 series
safety
shut-off valve
Wing Bolt
spark Plug
Heat regulator knob
Piezo
Ignition Hole
Burner Front
Place lit match through ignition hole.
TT30 series
Ignition Hole
safety
shut-off valve
Air Inlet Hole
5. Burner should light. Mesh screen on burner glows
red when lit. After burner is lit, continue holding in
safety shut-off valve plunger (about 10 to 30 seconds)
until heater stays lit.
6. If the burner does not light within 10 seconds, turn
regulator knob to the OFF position. Wait at least five
(5) minutes for the gas to dissipate before relighting.
7. If heater will not light after repeated tries, do not
attempt to repair heater. return heater to nearest
authorized service center or to the address on back
of this manual, freight prepaid.
8. After burner lights, turn the heater regulator knob to the desired heat setting (lOW, Med, or HI)
9. For dual burner models only : light both burners when maximum heat is needed. use one burner
to conserve fuel. repeat steps to light second burner.
