NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
7
To replace the igniter plug (Fig. 16);
Remove the batteries.
Remove the 2 Guard Bracket by removing 4 Screws and lift off the
Guard grill assembly.
Remove burner chamber and push the ignition lever to raise the
igniter plug.
Pull the igniter plug in and turn in a clockwise direction to remove.
Install a new igniter plug (Type "B", 2.5V DC, 1A only) by pushing it
in and turning it in a counter-clockwise direction.
Reassemble the heater and replace the batteries.
TEST IGNITION
Using the wick adjuster knob, raise the wick to its maximum height.
Push the ignition lever.
The igniter plug should be within 1~2mm of the wick when the ignition lever is fully engaged. (Fig. 13)
ADJUSTING THE WICK
After lighting the heater, it is important to check the heater flame within the first 5-7 minutes of operation.
During the first 5 minutes after ignition, the burner chamber warms up and flames will become visible at the top
of burner. These flames will gradually build up. After 5-7 minutes of operation, you should use the wick
adjuster knob to obtain the proper flame height. The proper flame height is a flame of no more than 1/2" at the
top of the burner, with an even distribution of flame around the flame spreader disk which is positioned in the
center of the top portion of the burner. See pictures below for reference.
As you continue to operate the heater, the temperature of the heater and the temperature of the room will
continue to change. As the heater warms up, the kerosene in the tank will vaporize faster, and this could
require adjusting the wick adjuster down in order to maintain the desired 1/2" flame height. Therefore, it is
necessary to continue to monitor the flame height, and to make adjustments using the wick adjuster knob to
keep the proper flame height. It is recommended that the heater be checked every 30 minutes in order to keep
the proper adjustment because periodic adjustment is required.
CORRECT FLAME
Proper combustion
IMPORTANT NOTE : NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING.
Always make sure to turn the heater off and inspect it to insure that it is completely
extinguished prior to going to bed.
FLAME TOO HIGH
Can Produce smoke
and soot
FLAME TOO LOW
Can produce odor
and carbon monoxide
Fig.16
WICK
FlLAMENT
IGNITER
1~2mm
Fig. 13
Fig. 14
Fig. 15
Fig. 16
