DURAG D-R 290, Руководство по эксплуатации

Страница: 116 / 202

6 | Commissioning
116 D-R 290
Once the PIN code has successfully been deactivated, the device is now
no longer
protected against accidental changes. The appropriate symbol (padlock crossed out)
is shown on the device detail page (see Fig. 6.12 ).
Fig. 6.12: PIN lock deactivated
In the bottom area, under the "Protocol" heading, there is a red cross. If you hover the
mouse cursor over this tick you are shown the message Quick Info [
}
196] "
Change
PIN code failed
". That means in this case that the old PIN code remains active.
Fig. 6.13: Change
PIN code failed
"Protocol" is
not a link, no protocol can be called up by clicking on it. The data availa­
ble and the red cross
are the protocol!
The dialogue box can be closed (only) by clicking on the × (at the top right of the box).
If the PIN code was not successfully changed (deactivated), the device is still protec­
ted against accidental changes. The old PIN code for the device remains valid!
Parameter checking or setting overview
The following table shows which parameters must be checked and set. The individual
operations are listed in functional sequence one after the other. The right-hand column
in the table indicates the section which contains detailed information about the respec­
tive check / setting.
At the start of this section you will find a box "D‑ESI 100 setting path" which shows the
path to the relevant menu in the setting software in which you can perform the listed
checks/settings.
Key word Range Component see section
1 Date, time* Bus information current date/time
●
set (manually)
●
synchronise time
7.2 Example: Settings for
checking / synchronising: Date
and time [
}
120]
2 Digital
communication
(DURAG−Modbus)*
Bus information Modbus address
Modbus communication
settings
7.3 Example: Setting – DURAG
– Modbus address [
}
121]
7.4 Example: Baud rate settings
[
}
122]
unsuccessful
6.7