DURAG D-LX 200, Руководство пользователя

Страница: 77 / 116

D − LX 200 InformationCentre PC Version
7.5 Error messages
In the event of an error shutdown an extra window opens, in which the error
numbers and, if available, the error plain text messages can be displayed. The
program continues to update the data.
As the D
− LX 200, D − LX 720 has gone into the so-called error position (red
"Error" LED on the front of the D − LX 200, D − LX 720), the old data is
repeatedly transmitted. In order to continue operation, the causes of the fault
must be eliminated if possible. The device must also be retrieved from the
error position by briefly interrupting the power supply or using RESET.
A possible error screen is displayed in Figure 7.10 .
Figure 7.10: Extra window with error message
7.6 Structure of the stored data records
The InformationCentre gives you the option of storing the determined data.
Information on the necessary settings can be found in chapter 7.4.1 File on
page 75. The storage process is started with the "Rec" key (see Figure 7.7 on
page 75). Data is now continuously written to the previously defined location.
The file content is structured as follows. The first part, only present once, is a
so-called header.
<HEADER> <SN>Frank00002 <DT>0011.4925.0000.0000 <FW1>04.70 R0007
<FW3>02.20 R0002 <END>
This header provides information on the master data of the device:

SN – Serial number

DT – Device Type

FW1 & FW3 Firmware & revision status of the device.
The measured data then follows in 195 byte sequences. There are no field
separators or gaps in the data record.
The following table describes the data record structure and the interpretation
of the fields.
D − LX 200, D − LX 720
77