IB-HT395-WM-E-073003
15
Home Theater TV + VCR + Satellite
TV + VCR + SATELLITE RECEIVER CONNECTIONS
1. Follow the above connection diagram and check if you have these items. If your VCR has AUDIO OUT jacks, you may
connect your VCR to your HOME THEATER as shown.
NOTE
: Your VCRs sound will come out of the 2 front speakers plus the subwoofer since the default setting for the
sound output is the same as the audio source from the VCR (2 channel, STEREO). For Dolby Pro Logic
(5.1 channel) sound reproduction, press the SURROUND button. The sound will come out of all 5 speakers
plus the subwoofer.
NOTE:
Some VCRs may not allow the Home Theater to play all 5 speakers if the audio output level of the VCR is
too low.
2. Connect your VCR to your TV using a coaxial antenna cable (probably already connected), your VCRs picture will go
to your TV through your existing antenna connection.
3. Use an antenna cable to connect the antenna output on the satellite receiver to the antenna input on the VCR the
same as you have it connected now. This audio HOME THEATER SYSTEM does not change any antenna connections.
4. Insert the AC power cord into an AC outlet.
5. Press the POWER button on the main unit (not the REMOTE) to turn on the main power of the set. Next press the
ON/STANDBY button on the REMOTE to turn the set on (or off).
6. Press the SOURCE button several times till the TV/VCR indicator lights.
7. Make sure your VCR is on and follow your VCRs instructions.
8. Go to Page 20 for detailed instructions.
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8
(OR THE QUICK SETUP DIAGRAM SHEET).
NOTE: On some TVs, this
jack is in the front.
