Page 6
eazi-rider - City
Operation
Motor Controller
The controller has 3 settings; low – high.
Press the
MODE
button until the desired level is
illuminated.
Turning On and Off
Before turning on the controller make sure that
the battery is locked in place.
Hold down the
ON/OFF
button until the
controller illuminates.
Now press the
LIGHT
button on the controller so that the indicator is illuminated,
this will power the headlight and horn.
Headlight
The headlight is switched on and off by pressing the red light
button that is located on the left hand side of the handle bars.
Note:
the headlight only works when the light setting on the
controller is turned on.
Horn
The horn button is located underneath the headlight button.
Press to sound.
Note:
The horn only works when the light setting on the controller is turned on.
Pedal Assisted Level
The motor power will remain at the level previously selected until a new level is
set.
It is possible to use the bike with no assistance, simply leave the controller turned
off.
Note:
The light and horn will not work if the controller is turned off.
Push Power Assistance
To activate, hold down the
MODE
button.
Shortly the bike will start to propel itself, up to 6km/h.
Release the button to stop.
eazi-rider - City
Page 7
Folding the bike
Before folding the bike ensure that:
- The battery is turned off and the key removed.
- The rear wheel is locked and the key removed.
- Place the right hand pedal downward (slightly ahead of vertical – 8 o’clock)
Handle Bars
- Open the middle quick release catch and lower the handle bars.
- Close the quick release catch locking the handle bars in position.
- Slide the safety ring from the lower release catch.
- Pull the release catch down folding the handle bars to the side.
Seat
- Open the quick release catch and lower the seat completely.
-
Close the quick release catch locking the seat in position.
Frame
- Open the quick release locking catch and pivot away from the frame.
- Lift the locking catch, note this is spring loaded and can be a little stiff, and
partially fold the bike so that the catch can be released and the bike remains
hinged open.
- Close the kick stand and keep hold of the bike to prevent it from falling over.
- Now complete the folding process.
Reverse the process to re-assemble the bike ensuring that all the safety catches
are securely located.
