Dura Vac CVQ810PF, Руководство оператора

Страница: 6 / 12

6
A Philips head screwdriver is required for assembly.
WARNING
: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig.4)
5.
With the power head removed, turn the container upside down. Insert the feet with casters into the slots
and apply pressure into place and secure them with supplied screw. Do not over- tighten screws. (fig.5a)
6. Insert the handle into the slots located on the top of the power head and secure it with the screws
provided. Do not over tighten the screw. (fig.5b)
7. Your vacuum comes ready for dry vacuum cleaning with cartridge filter pre-installed. If cartridge filter is
not installed, refer to page 10 for filter installation. (fig.6 & 7)
8. Optional, for improved dust filtering, fit collection bag flange onto the vacuum port deflector, taking care
not to damage the bag. (fig.8)
9. For wet vacuum cleaning, install the supplied foam filter. (fig.9) See page 11 for filter installation.
10. Place the power head back on the container, and secure into place using the 2 side latches.
(fig.10 & 11)
11. Secure the large end of the hose into the vacuum port on the container and lock into place. (fig.12)
12. Choose the desired accessories and extension wands and push onto the suction tube. (fig.13)
GENERAL ASSEMBLY INSTRUCTIONS