INSTALLATION OF THE FAUCET
1
Remove Mounting Nuts
Remove the mounting nut (10) and
washers (8 & 9) from threaded collar of
the spout (6). Remove the mounting nut
(5) and nylon washer (4) from the threaded
collar of the body (2). Note that the black
rubber gasket (3 & 7) at the base of the
faucet body (2) and spout (6) remains in
place to create a seal after the faucet is
installed.
2
Install Faucet Spout
Install the faucet spout (6) through the
hole in the sink. Slide washers (8 & 9) to
the threaded collar followed by the
mounting nut (10). Thread the mounting
nut to the underside of the sink and
tighten.
3
Install Faucet Body
Install the faucet body (2) through the hole
in the sink. Slide the nylon washer (4) up
to the threaded collar followed by the
mounting nut (5). Thread the mounting nut
to the underside of the sink but do not
tighten yet.
4
Position Faucet Body
Determine the direction you would like the
handle to face when in the off (down)
position. Generally, when installed in the
center of the sink, this would be straight
forward and when installed in the corner,
it would be positioned diagonally across
the sink. Center the faucet through the
hole in your sink and then hold the faucet
body (2) in place. Tighten the mounting
nut until the faucet is secure being careful
not to over tighten.
5
Connect Hoses
Connect the spout supply (13) to the
faucet spout. After doing so, connect the
hot water supply to the longer of the two
flexible supply hoses and the cold water
supply to the shorter. Flexible supply
hoses are complete with
½
-inch I.P.S.
fittings for your convenience. We have
also included nose cone washers and
brass supply nuts for use with copper
tubing.
6
Remove Aerator and Check
Water Connections
Remove the aerator from the end of the
spout and run the water for 30 to 60
seconds to flush the lines. While doing
this check to ensure that all of the
connections are tight and there are no
leaks. Reinstall aerator.
MAINTENANCE AND CLEANING
Cleaning Tips: The finish on your product
is designed to retain its beautiful sheen
for years. To maintain the original look of
the finish, a little care and caution should
be used. We recommend the use of mild
soap and water to clean the product.
THE USE OF ABRASIVE CLEANERS MAY
SCRATCH THE FINISH OR CAUSE
OTHER DAMAGE.
RECOMMENDED TOOLS AND
MATERIALS
¨
Adjustable Wrench
¨
Plumbers Tape (Thread Seal
Tape)
¨
Phillips Screw Driver
BEFORE YOU BEGIN
There are a variety of things to do before
installing any new plumbing system into
your home or residence. Before you begin
work make sure you:
¨
Shut off the main water supply
¨
Cover your drain to prevent
loss of parts
¨
Observed any local plumbing
codes
¨
Inspect fixture for damage -
Replace as necessary
Dura Faucet reserves the right to make
any revisions in the design of products
without notice.