24
24. Tighten all fasteners.
25. Check that DuoGen pivots freely from wind mode position to water mode. Release ‘C’ bracket
pivot lock mini wing and ensure DuoGen pivots freely from side to side. Centralise the
alternator yoke, re-tighten the ‘C’ bracket pivot lock. Raise DuoGen back to wind mode position.
Ensure that the upper tower clamp strap closes properly and securely with an audible snap. If it
does not, or requires undue force to close it, re-check alignment.
26. Fit nut covers and Tower lock warning sticker.
27. Decide where to bring the cable into the yacht and fit a deck gland. (Do not use deck plugs and
socket.) Allow a reasonable loop of cable so that the cable is not strained as DuoGen pivots
between modes. Raise and lower the machine to make sure the cable runs free.
28. Make the electrical connections in accordance with the guidelines in the manual, and ensure
you fit the in-line fuse. If in doubt, seek qualified assistance.
29. If at any point you experience difficulty or are unsure about how to proceed, contact us.
We will do everything we can to assist you.
Installation without existing pushpit rails.