EJF1 ERIC JOHNSON SIGNATURE FUZZ FACE
POWER REQUIREMENTS
The EJF1 Eric Johnson Fuzz Face
requires one 9 volt battery. Unscrew
the bottom of the pedal to access the
battery clip. Remove the instrument
cable from the input jack when not in
use to extend battery life.
SPECIFICATIONS
Input Impedance
10 k
Output Impedance @ 1 kHz
16 kΩ
Maximum Gain
55 dB
Current Draw
500 uA @ 9 VDC
Bypass
True Hardwire Bypass
*All specifications are measured at 1 kHz
DIRECTIONS
• Run a cable from your guitar to
the Fuzz Face’s Input jack and run
another cable from the Fuzz Face’s
Output jack to your amplifier.
• Set the Fuzz Face’s controls to their
12 o’clock position.
• Turn the effect on by depressing
the footswitch.
• Dial in the amount of desired fuzz by
adjusting the FUZZ knob.
• Use the LEVEL knob to set the
desired volume level of the effect.
• Try rolling back your guitar’s volume
knob to clean up the Fuzz Face.
CONTROLS
• Footswitch toggles effect on/ bypass
• Volume knob controls total
output level
• Fuzz knob controls intensity of the
fuzz tone
