
3 … 9
2 … 9
MC • Karl Dungs
, Inc.
• EMP-5 • Edition 2017.05 • P/N 261483
Specification
EMP-5
The EMP-5 series actuators provide damper control or valve control where it is desirable to move the crank
arm in either direction, or to stop it at any point in the stroke with a voltage or current input. These actuators
are NEMA Type 4.
Ambient Temperature
-40 °F to +136 °F (-40 °C to + 58 °C)
Note: Surface temperature during
normal operation can reach 40 °F
above ambient.
°F
0
-40
+136
Electrical Ratings
120 VAC (+10 % / -15 %); 60 Hz
Input Control
4 - 20 mA or 0 - 10 VDC
Power Consumption
78 VA; 0.65 A
Deadband Adjustability (Hysteresis)
Factory set at 3 %, adjustable to 5 %
Resolution
40 steps over 90° at factory setting.
A minimum of about 0.4 mAdc is
needed to drive actuator one step in
same direction.
Auxiliary Switch Ratings
5.8 A Running; 34.8 A locked rotor
Grounded Input
Grounding either or both input wires
will not cause.
Fuse
There is no internal fuse. The EMP is
impedence protected.
Model No .
Order No . Travel
Description
Timing
(seconds)
Torque
(in .- lbs .)
Weight Lbs .
(actual/shipping)
EMP-423-5
267229
90°
Fixed timing
12 s
60
9/10
EMP-424-5
269223
90°
Adjustable timing 12 s*
60
9/10
EMP-453-5
269224
90°
Fixed timing
40 s
220
9/10
EMP 454-5
269226
90°
Adjustable timing 40 s*
220
9/10
* up to approximately ten times the fixed timing.
Open circuit Input
Drives actuator to low
Series Operation
No offset in control point when oper
-
ated in tandem max. 3 slaving pro-
portionating; current input 250 Ohm.
Overranging
No effect from 100 % overrange
signal.
Enviroment and Mounting Position
NEMA Type 4; multipoised (best not
to have shaft pointing downwards
)
NEMA
Electrical Connection
Terminal block with 1/2” NPT conduit
knockout
[
V
]
[
A
]
[
Hz
]
[
VA
]
Cycling Rate:
EMP is rated for 100 % duty cycling &
continous cycling. Cycle life rating is
100,000 cycles (0-90°/cycle).