CHANGING MODULES
Both factory installed preamp modules are located on the right hand rear of the amp.
Changing modules is quick and easy. Dramatic tone changes are possible when you try
new modules. To remove and replace modules, just follow these easy steps.
TO REMOVE
1.UNPLUG YOUR AMP from the power outlet.
2. Let the amp cool down for one full minute.
3. Firmly grasp the module spring retainer with your finger and thumb.
4. Lift up and toward you. The spring will release its tension on both modules.
5. Firmly grasp the module you want to replace by its handle and slowly pull toward you.
TO REPLACE:
1. MAKE SURE THE AMPLIFIER IS STILL UNPLUGGED.
2. Choose the module you want to install and grasp its handle.
3. Align the module plug to be installed in front of the receptacle in the channel you have
selected.
4. Slowly insert the module into the receptacle. Apply moderate pressure until You feel
the module is seated snugly.
5. Repeat steps 2 through 4 for the other channel's module if you want to replace that
one, too. When you have finished changing modules, double-check both modules to
ensure they are still snug in their receptacles.
6. Firmly grasp the module spring retainer and move away from you and up until it clears
the module handles, When in its proper position, the retainer will rest on top of the
module handles and hold them tightly in place.
7. Make sure the Volume controls are at a low setting and plug the amp into the power
outlet-
8. Turn on the power switch and wait one minute for all the tubes to warm up.
9. Plug in your guitar and check out the new sound you've created.
