8
4. Unscrew and transfer the middle hinge
○
,12
and the middle fixing plate
○
,11 to the
opposite position. (Fig. 5)
5. Pop out the cover caps on the left side of
cabinet and use them to
cover the screw holes
on the right hand side.
6. Screw the alternative left top hinge
○
,9 ,
included in the fittings,
on the left hand side of
cabinet. (Fig. 4)
7. Relocate the door adapter
○
,14 on the middle
hinge.
8. Set the upper glass door to the designated
position and install the two lock screws to
connect the door adapter
○
,14 with the upper
glass door and tighten them before the door is
leveled.
9. Set the lower glass door to the designated
position and reassemble the bottom hinge.
10. Recheck and adjust the lower door alignment
by loosening the screws
○
,5 &
○
,6 and
moving the door adapter
○
,4&
○
,7. Tighten
the screws
○
,5 &
○
,6 after the door is
levelled. (Fig. 5)
11. Transfer the handles and plugs to the opposite
positions.
OPERATING YOUR
APPLIANCE
This appliance is designed for operation at certain
ambient temperatures. The climate class is specified
on the rating plate.
The appliance may not work properly if it is left for a
long period at a temperature outside the specified
range. For example, placing your unit in extreme
cold or hot conditions may cause interior
temperatures to fluctuate. The range between 5ºC
and 22ºC (41ºF and 72ºF) may not be reached.
Climate class
Ambient room temperatures
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
NOTE:
Units with no heater will not raise their
internal temperature if the ambient temperature
where the unit is located is lower than the set
temperature.
USE AND CONTROL – SINGLE ZONE
The Controls of Your Unit
POWER
To turn the appliance on/off, press and hold the
key for 5 seconds until themperature display lights
up or goes out.
NOTE:
Pressing the key once can switch off the
audible alarm when the alarm is on.
LIGHT
Used to turn the inner light on/off.
UP
Used to increase (warm) the set temperature by
1°C/1ºF.
DOWN
Used to decrease (cool) the set temperature by
1°C/1ºF.
Display
Display the digital temperature and service
indicators.
Indicator Light
The indicator light is located at the right lower corner
of the display. The indicator light will be on when the
multi-key function is selected. To perform the multi-
key function, press and hold the first key, then press
the other key for at least 5 seconds and then release
all the keys.
ºF/ºC
Selector
Select the temperature display setting in Fahrenheit
or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit,
press and hold the
LIGHT
key for 5 seconds.
NOTE:
When you use the appliance for the
first time or restart the appliance
after
having been shut off for a long
time,
there could be a few degrees
variance
between the temperature you
select
and the one indicated on the
LED
readout. This is normal and it is
due
to the length of the activation time.
Once the unit is running for a
few
hours everything will be back to
normal.
If the unit is unplugged, power lost,
or
turned off, you must wait 3 to 5
minutes before restarting the unit. If
you attempt to restart before this time
delay, the unit will not start.