15
UNCONTROLLED IF PRINTED QSP-711-99-1
20190815
MAINTENANCE OF YOUR WEIGHT & TRIM III SYSTEM
Proper maintenance of your Weight & Trim III System is very important. It is very
simple to care for and requires a minimum amount of attention.
POST DIVE CARE
• Rinse the entire system thoroughly with fresh water.
• Remove the weights from the pockets and flush the pockets with
fresh water. This will remove any sand or other matter that may have
accumulated in the pockets.
• Do not dry in direct sunlight.
• Do not store with the weights in the system.
• Store in a cool dry place.
REATTACHING WEIGHT POCKETS OF THE WEIGHT & TRIM III SYSTEM
If you have released the weights you will need to reattach them by engaging the
release handle before you can use the Weight & Trim III for diving again. This is a
very simple procedure that can be accomplished in a few seconds. There is a left
and right weight pocket assembly. They are not interchangeable.
To install the weight pockets perform these steps:
1. Insert P3 into P1/P2 Assembly
2. Insert Weight Release Handle (P4) through P1/P2/P3 Assembly, ensuring that
P4 snaps in securely. As seen in (Figure A)
Figure A
Pockets have been removed
from this illustration allowing
you to see the docking
mechanism
MAINTENANCE
