Duff-Norton TracMaster 6415 Series, Руководство пользователя

Страница: 11 / 16

11
Figure 4-1. Potentiometer Nut & Washer
38. Asembly of Fuse Holder in Cover (9)
a. Connect jumper wire (69) to one terminal of fuse
holder body (70a).
b. Install fuse holder body (70a) into cover.
c. Apply Permatex 2 Non-Hardening Sealant to
threads of cap screws (71) and install in cover (9)
to fasten fuse holder body (70a) in place.
39.Assembly of DC Cover
a. Connect motor lead wire to other terminal of fuse
holder body (70a).
b. Feed motor (53) lead wire with terminal and
jumper wire (69) terminal thru cover (9) (care
should be taken not to damage wires). Assemble
cover (9) on housing (42) aligning dowel pins
(27) with dowel pin holes in cover (9). (A light tap
with a soft hammer may be required.)
c. Install lock washers (8) and button head cap
screws (7).
d. Install fuse (72) in fuse holder cap (70) and install
assembled fuse (70B) and body cap into fuse
holder body (70A).
e. Feed terminal wires, (17) red, (18) blue, fuse
jumper wire, and motor lead through 1/2” tapped
hole in cover capacitor box outside of cover.
f. Insert insulation (4) and assemble gasket (3) and
cover (2) with screws (1).
g. Adjust actuator limit switch settings per
instructions in paragraph 2-2.
h. If actuator has potentiometer, refer to position
indicator installation and calibration instructions
in Paragraph 2-4.
I. Attach gasket (12) and cover (11) with screws
(1).
ASSEMBLY IS NOW COMPLETE.