Duevi DIRFE, Инструкция по эксплуатации

Страница: 18 / 20

18
12. LEARNING (ONLY DIRRVE)
To learn DIRRVE detector:
1. Give power supply to detector and wait until the end of starting stabilization (about 30 s) until all LED are off.
2. On the control panel, enter in radio zone learning “ by tamper ”, ready to receive wireless codes of the detector.
3. Let both heads detect.
4. As soon as all three LEDs are on, press and hold tamper button:
Check on the control panel that the learning is done properly.
Note : it is possible to learn the detector also “by detection” on devices not compatible with “by tamper” mode.
13. SUPERVISION (ONLY DIRRVE)
When the supervision is enabled, the sensor sends regularly the “in life” code.
The control panel and/or the receiver (if enabled) verify continuously this “presence” of the sensor: in case the “in life” code is not received
they activate all the “missed supervision” alerts.
The supervision code is sent by sensor after about 1 hour from last transmission. The alarm transmission is also a “in life” code.
ENABLE THE SUPERVISION DISABLE THE SUPERVISION

Disconnect the battery

Open the JP6 jumper (cover anti-opening)

Connect the battery: the supervision is enabled

Disconnect the battery

Close the JP5 (anti-removal) and JP6 (cover anti-opening) jumpers

Connect the battery: the supervision is enabled
Note : to have supervision control it is necessary to enable such feature on control panel and receiver