DUDOFF VENUS-DV01, Инструкция по установке и эксплуатации

Страница: 47 / 49

43
Things To Be Done In Case Of Simple Failures
Your appliance will report the cause of the error as an error code if it is in failure
mode. Error codes will be displayed on the screen of your appliance. Following
chart shows these error codes, their definitions and points to be checked.
ERROR
CODE ERROR DEFINITION CONTROL
F5 Water inlet is inadequate
Make sure that the water inlet tap is completely turned on and
the water is not cut off.
Turn off the water inlet tap and clean the filter on the connect-
ing terminal of the hose by removing the water inlet hose from
the tap.
Switch on your machine again and if the failure persists, consult
a service agent.
F3
Continuous water intake
failure
Close the tap
Consult a service agent.
F2
The machine can no longer
discharge the water.
The water discharging hose may be clogged.
The filters of your machine may be clogged.
Switch your machine off and on and enable the programme
cancellation command
If the failure persists, consult a service agent.
F8 Heater failure
Consult a service agent.
F1
The anti-overflowing alert
is active
Turn off the appliance and close the tap.
Consult a service agent.
F7
Overheating failure (the
temperature inside the
machine is too high) Consult a service agent.
F9 Divisor position error
Consult a service agent.
F6
Temperature sensor is
faulty Consult a service agent.
FE
Electronic card parameter
identification failure
As a result of very sudden and sustained voltage dips, the elec-
tronic card cannot keep the software variables in the memory.
The programme will resume after being re-operated. The mains
voltage must be checked.