DUDOFF MH-F2B, Инструкция пользователя

Страница: 6 / 12

6
INSTALLATION INSTRUCTIONS
These installation instructions are
intended for a specialized installer
and are meant as guidelines for the
hob installation, adjustment and
maintenance, in compliance with any
regulations and standards in force. If
a built-in oven or any other appliance
generating heat is to be mounted
directly under the vitro-ceramic hob,
IT IS NECESSARY THAT SUCH
AN APPLIANCE (the oven) AND
THE VITRO-CERAMIC HOB ARE
PROPERLY INSULATED . Failure
to comply with this precaution might
result in the incorrect operation of the
TOUCH CONTROL system.
POSITIONING
This household appliance has been
designed for built-in installation onto a
worktop, as shown in the figure (Fig.2).
Use sealing material along the whole
perimeter - Fig.4 (Cut dimensions-
Fig.2). This operation is necessary
in order to prevent any liquid from
entering inside the hob, being that the
flatness of the top, the glass and their
coupling cannot be assured.
Fix the appliance on the worktop by
using the 4 supports, taking the work
top thickness into account (Fig.2).
If, after installation, the lower part of
the appliance is accessible from the
lower part of the cabinet, it will be
necessary to mount a spacing panel at
the distances given (Fig.3).
If the appliance is installed under an
oven, this step will not be necessary.
The appliance is not intended to be
operated by an external timer or a
separate remote control system.
VENTILATION (Fig.5)
The distance between the cooktop and
built-in kitchen’s furnitures or cooking
apparatuses must guarantee sufficient
ventilation of the air. Not to use the
cooktop if in the oven is in course the
pyrolysis process.
ELECTRIC CONNECTIONS (Fig.7)
Before carrying out any electric
connections, please make sure that:
- the ground electric cable is 2 cm.
longer than the other cables;
- the electrical system meets any
requirement mentioned in the rating
label found on the underside of the
work top;
- the electrical system is equipped with
an efficient grounding system and
compliant with any standards and law
directives in force.
In the case the appliance is not
equipped with a power cord and/or
the related plug, please use a material
suitable for the power absorption value
mentioned in the rating label and for
the operating temperature. If a direct
connection to the electric network is
required, you need to use an omnipolar
power switch with a switch-contact gap
of at least 3 mm, suitable for the value
mentioned in the label, and compliant
with the related standards in force (the
yellow/green ground connection shall
not be interrupted by the change-over
switch).
Once the appliance installation is
completed, the omnipolar switch shall
be easily accessible.
WARNING! THIS APPLIANCE MUST
BE GROUNDED
The electrical safety of this appliance
can only be guaranteed when continuity
is complete between it and an effective