DUCATIHOME 8500V-Rol/ DUCATI UP 70 (CTH29E), Руководство по установке

Страница: 15 / 19

P1 = storage/erasure of codes for the remote control or the
radio keypad (optional accessory)
LED = Red light. Power supply on and indicator for radio
code storage
RV1 = power adjustment trimmer
M = connection to motor
ST = start n.o.(contact normally open)
FTC = n.c. photoelectric cells (contact normally closed)
Com = common
+ = power 24V
IMPORTANT: if the optional photoelectric cells have
not been connected, the jumper connecting FTC and
COM must be in place. Otherwise, the automation
system will no longer close!
11. CTH29E circuit board
P1
LED
Hybrid receiver
Aerial
RV1 = power
adjustment
Halogen bulb 20V
24W
Connectio
n to
transforme
r red (24V)
and black
(0) cables
Connection “M”
motor cables
red (left) blue (right)
ST FTC Com +
START
Photoelectric
cell
transmitter
(optional)
Photoelectric cell
TX (optional)
0,5 mm 2 cable
0,5 mm 2 cable
0,5 mm
2
cab
le
0,5 mm
2
cab
le
This circuit board is equipped with an amperometric safety system.
If an obstacle is detected, it stops movement.
It automatically stops movement in opening and closing directions (amperometric detection).
Connection for optional accessories: Photoelectric cells (Ref. SW7012); key-operated switch (Ref. SW5000).
-
+
BLUE
motor
cable
230V
Alimentation
RED
motor
cable
BLUE
motor
cable
transformer cables
RED and BLACK
RED
motor
cable
+ -
IMPORTANT: do not
remove the jumper
between the FTC
and COM terminals
except in the event of
connection of a pair
of photoelectric cells.
Otherwise, the
automation system
will no longer close.
Fig. 47
Fig. 48
0,5 mm
2
cab
le
Page 15
Key-operated
switch
(optional)