5
b)
operate the machine only in daylight or in good artificial light;
c)
avoid operating the machine in wet grass or take additional precautions to avoid slipping;
d)
always be sure of your footing on slopes;
e)
walk, never run;
f)
always work across the face of slopes, never up and down;
g)
exercise extreme caution when changing direction on slopes;
h)
do not operate the machine on steep slopes;
i)
use extreme caution when reversing or pulling the machine towards you;
j)
stop the tines if the machine has to be tilted for transportation. Do not operate the tines when crossing
surfaces other than grass, and when transporting the machine to and from the working area;
k)
never operate the machine with defective guards, or without safety devices, for example deflectors
and/or catchers, in place;
l)
do not change the engine governor settings or over-speed the engine;
m)
disengage all tine and drive clutches before starting the engine;
n)
start the engine carefully according to instructions and with feet well away from the tine(s);
o)
do not tilt the machine when starting the engine, except if the machine has to be tilted for starting. In
this case, do not tilt it more than absolutely necessary and lift only the part which is away from the
operator;
p)
do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all
times;
q)
never pick up or carry a machine while the engine is running;
r)
avoid operating the machine in bad weather conditions especially when there is a risk of lightning;
s)
stop the engine, disconnect the spark plug wire and for battery start machines remove the
ignition
key:
1)
before clearing blockages or unclogging chute;
2)
before checking, cleaning or working on the machine;
3)
after striking a foreign object. Inspect the machine for damage and make repairs before restarting
and operating the machine;
4)
if the machine starts to vibrate abnormally (check immediately);
t) stop the engine, disconnect the spark plug wire and for battery start machines remove the
ignition
key:
1)
whenever you leave the machine;
2)
before refuelling;
u) reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off
valve, turn the fuel off at the conclusion of aerating or scarifying.
3.4 Maintenance and storage
a)
Keep all nuts, bolts and screws tight to be sure the machine is in a safe working condition;
b)
never store the machine with petrol in the tank inside a building where fumes can reach an open
flame or spark;
c)
allow the engine to cool before storing in any enclosure;
d)
to reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area
free of grass, thatch, moss, leaves or excessive grease;
e)
check the catcher frequently for wear or deterioration;
f)
examine the machine regularly and replace worn or damaged parts for safety;
3.3 Operation
Содержание DR40
Страница 7: ...4 7 1 6 5 6 5 4b 3 4a 2 1 3 2 3 7 8 9 11 7 10...
Страница 8: ...15 14 13 12 11 a 10 min max A B 9 4 8 8...