20
21
6MM
6MM
2-END
DUALIT
TROUBLESHOOTING
MY TOASTER IS NOT WORKING:
• Check the toaster is plugged in.
• Check if the ‘neon’ is glowing red when the timer is activated.
If yes, your elements, ‘selector’ switch or your thermal fuse may need replacing.
If no, your plug fuse may have blown or your timer may need replacing.
I GET UNEVEN TOASTING:
• Check the selector switch is set for the number of slots being used.
• Starting from the left, ensure you have loaded all heated up slots.
• The heavy duty Proheat elements can take a few moments to reach optimum toasting
temperature. Preheating the slots prior to inserting your bread will eliminate this. Rotate the
‘timer’ all the way round, let it wind down to the circle indicator then insert your bread into
the active slots.
• Ensure size and type of bread being toasted is the same.
• End elements take a little longer to warm up than centre elements, once toaster is at
optimum operating temperature this will no longer occur.
• If the timer is noticably slow, isolate and do not use the toaster. Spare timers are
available from www.dualit.com and must be fitted by a qualified electrical engineer.
MY TOASTER WOBBLES ON MY WORK SURFACE:
• Use the adjustable foot under the toaster to compensate for uneven surfaces.
MY TOAST GETS STUCK WHEN I EJECT FROM THE TOASTER:
• Unplug and allow to cool before attempting remove the toast. Note: slices thicker
than 28mm will get stuck. Hand cut slices must be cut evenly.
• Using a ‘sandwich cage’ can make toasting thicker items easier.
ONE SIDE OF MY BREAD IS NOT TOASTING:
• Check the ‘selector’ switch is set correctly and insert bread from the very left hand slot.
• One or more of the elements may need replacing, call the helpline or visit
www.dualit.com for replacements.
REPLACING ELEMENTS
ALL SERVICING MUST BE CARRIED OUT BY A
QUALIFIED ELECTRICIAN OR REPAIRER & PORTABLE
APPLIANCE TESTED.
TO REPLACE FUSE,
REMOVE SILVER LABEL
TO ACCESS SCREW.
6MM
6MM
2-END
DUALIT
1
Unplug and place toaster on
a soft cloth. Remove crumb
tray and unscrew feet
to remove the base plate.
Loosen locking nuts on
retaining plate using a
6.5mm spanner and
slide back.
Ensure that
the retaining plate is
correctly in position
when reassembling.
3
Unscrew brass links and
wires.
U
N
PL
U
G
W
HEN N
OT
IN
U
SE
6MM
6MM
2-END
DUALIT
4
Bend brass links and wires
away from the element.
Remove element. To reassemble, reverse procedure
ensuring wires and parts are correctly positioned. Ensure new
element is marked the same as the one removed.
The element heats on both sides and can be inserted facing
either way. Check it is seated correctly in the channels either
side. Portable Appliance Tested before use.
5
6MM
6MM
2-END
DUALIT
6MM
6MM
2-END
DUALIT
2
