WATER FILTER
SURE POUR
™
SPOUT
LID SEAL
HINGED LID
KNOW YOUR DOMUS KETTLE
1
Place the kettle as close to the wall
socket as possible. When in use ensure
the kettle is not placed under kitchen
cabinets.
DO NOT STORE OR
USE YOUR KETTLE IN AN
APPLIANCE GARAGE OR
UNDER CUPBOARDS.
BEFORE FIRST USE: FILL TO THE MAX MARKER, BOIL AND THEN DISCARD WATER. REPEAT THIS PROCESS TWICE.
Use the shortest cord possible.
Wrap excess cord round the
cord tidy on the base of
the kettle.
Do not operate on an inclined
plane.
Do not operate in a tray.
POSITION
SETTING UP
All illustrations are for representation only, your model may vary from illustrations shown.
3
4
INCLINED PLANE
NOT IN A TRAY
2
CORD TIDY
In the interest of improving products, Dualit Ltd. reserves the right to change the product specification without prior notice.
FILLING YOUR KETTLE
Ensure the kettle is unplugged. Remove the
kettle from the power base. Lift the lid latch in
location shown, and pull back to open.
WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED. THE LID WILL BE HOT.
Fill the kettle through the hinged lid opening.
Use at least one cup of water (250ml). The water
level must stay below the ‘max’ mark. Save
energy, only boil what you require. Keep kettle
upright and level at all times when filling. Do not
tilt kettle backwards.
DO NOT OVERFILL
OR FILL THROUGH THE SPOUT.
Push the lid down until it clicks and check it is
firmly in place, otherwise the kettle may not
switch off when boiling.
WARNING: IF THE KETTLE HAS
JUST BOILED, THE METAL PARTS
OF THE LID WILL BE HOT.
BOILING WATER
1
Plug the kettle into the power socket. Press
the ‘On/Off’ switch down. The power light will
illuminate and the kettle will start to heat up.
If the kettle is accidentally switched on with no
water inside, the boil-dry device will switch off the
heating element to prevent damage to the kettle.
The kettle will automatically turn off after the
water has boiled.
To turn off before the water has boiled lift the
‘On/Off’ switch up.
Always unplug the kettle after each use.
Remove kettle from the power base.
To avoid the risk of splashing, once the kettle
has boiled wait 10 seconds then pour slowly.
Do not over-tilt the kettle.
TURN ON
3
POURING
2
TURN OFF
CLEANING & CARE
Unplug and let the kettle cool down
completely before cleaning. Remove the
kettle from the power base.
Wipe the outside and inside surfaces of the
kettle with a soft, damp cloth.
Open the lid. Hold the top of the filter, pull
it gently up and out of the kettle. Rinse it
under a tap while carefully brushing it with
a soft brush. Rinse the kettle out with fresh
water.
DO NOT OPERATE KETTLE
UNLESS THE WATER FILTER IS
CORRECTLY IN POSITION.
To replace, align the sides of the filter with
the grooves in the filter holder, and slide it
slowly downwards and back into place.
Use descaling products suitable for kitchen appliances, these are readily available online or from most supermarkets or department stores. Use as
per instructions on the packet.
Follow these few simple steps to minimise scale build up in your kettle: Empty the kettle after each use; do not allow water to stand in the kettle
overnight. Use filtered water instead of tap water. Descale the kettle regularly, at least once a month. If you live in a hard water area you may
need to descale more often. When descaling has finished, empty the kettle and rinse it out a minimum of 3 times with fresh water, then refill
with fresh water, boil, then discard boiled water.
FAILURE TO DO SO CAN CAUSE INJURY. DO NOT BOIL KETTLE WITH
DESCALING SOLUTION IN IT.
DESCALE REGULARLY
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life cycle. Please hand
it over to a collection point for the recycling of electrical and electronic appliances. The symbol on the
product, the instruction of use or the packaging will inform you about the methods of disposal. The
materials are recyclable as mentioned on its marking. By recycling, material recycling or other forms of
re-utilization of old appliances you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorised disposal location.
POWER BASE
POWER CONNECTOR
POWER LIGHT
VIEWING WINDOW (CUPS)
MAX MARK INDICATOR
CORD TIDY
POWER CORD
HANDLE
VIEWING WINDOW (LITRES)
ON/OFF SWITCH
LID LATCH
BPA FREE
BPA FREE
BPA FREE
BP
A FREE
U
N
PL
U
G
WH
EN NO
T IN
U
SE
PL
UG
IN
BEFORE
U
SE
BP
A FREE
U
N
PL
U
G
WH
EN NO
T IN
U
SE
PL
UG
IN
BEFORE
U
SE
BP
A
FRE
E
1
THE BODY
BPA
FREE
U
N
PL
U
G
WH
EN NO
T IN
U
SE
PL
UG
IN
BEFORE
U
SE
2
REMOVE WATER FILTER
3
INSERT WATER FILTER
2
BP
A FREE
BP
A FREE
FILLING
1
2
1
3
CLOSE HINGED LID
OPEN HINGED LID
