16
17
1
2
Align the Filter Holder with the
open lock symbol, insert then
rotate 60° past the closed lock
symbol.
Ensure the Holder
is fully locked before
dispensing. Risk of
scalding.
Place 1 or 2 warmed
cups directly under the Nozzles
of the Filter Holder.
To extract, press the espresso
or double espresso Auto
Dosing button. To extract tea,
press the tea Auto Dosing
button.
Caution: Never use
Auto Dose Tea function
with coffee capsules.
3
If the machine stops mid
extraction, discard and
replace the capsule, ESE pod
or ground coffee and restart
by pressing the required
Dosing Button.
COFFEE & TEA EXTRACTION
When switching from coffee to tea, all dosing buttons may flash due to the Thermobloc
heating water to your chosen temperature. When switching from tea to coffee, the machine
may purge to cool the Thermobloc. This is normal operation.
PLEASE CAREFULLY
SELECT REQUIRED BUTTON. FAILURE TO DO SO MAY BLOCK YOUR
SHOWERHEAD, PREVENTING OR SLOWING DOWN EXTRACTION.
CAUTION: DO NOT USE TEA BUTTON WITH COFFEE CAPSULES, THIS
MAY DAMAGE YOUR MACHINE AND INVALIDATE YOUR WARRANTY.
EXTRACTION
SELECT AUTO
DOSE
ATTACH HOLDER
LOCK
4
5
When the correct dose has
dispensed, the machine will
automatically stop.
Allow to
cool for 10 seconds before
removing NX Holder.
All
Auto Dosing buttons will illuminate
when ready for the next extraction.
Unplug when not in use.
Stop extraction mid cycle by
pressing illuminated Dose
Button, when pressed again
full dose cycle will resume.
Dispense a cup full of
water through the machine
between making a coffee
and tea to prevent tainting.
6
BETWEEN DRINKS
MANUALLY STOP
EXTRACTION
STOP
EXTRACTION
7
8
When using the Filter Holder,
knock out the grounds over a
bin. Rinse the Filter under
running water to remove any
coffee grounds. Use the Filter
Pin to unblock the filters or
NX
®
Adaptor if required.
Turn machine off by pressing
Power ON/OFF Switch after
you have rinsed through and
finished using the machine.
This will save energy.
Unplug when not in use.
TURN OFF
CLEAN FILTER OR
NX
®
ADAPTOR
WHEN SWITCHING FROM STEAM TO COFFEE OR
TEA EXTRACTION: WAIT 10 SECONDS BEFORE
REMOVING THE HOLDER AFTER DOSING FIRST DRINK
IS COMPLETE.
U
N
PL
U
G
WH
EN NO
T IN
U
SE
1
2
Press the Steam Button. It will
flash red until the temperature
is correct for steam, then it will
turn solid red.
Put the Froth Nozzle on the
end of the Steam Wand.
Push up against the Stopper
shown above.
Caution:
Wand may be hot. Risk
of scalding.
3
Use 75-200ml of
cold
semi-skimmed milk
in a
stainless steel jug.
Position
the head of the Froth Nozzle
just under the surface of the
milk.
Risk of scalding.
FROTHING MILK
IMPORTANT NOTICE: AFTER EACH USE, WIPE THE STEAM WAND &
FLUSH THE INSIDE OF THE WAND BY DISPENSING WATER THROUGH
THE WAND.
POSITION JUG
ATTACH NOZZLE
SELECT STEAM
CAUTION! Take care when using the Milk Jug, as edges may be sharp.
