11
10
POURING
The kettle features an oversized non-drip smooth flow spout.
• Remove the kettle from the power base before pouring
• When filling or carrying the kettle, do not tilt it
backwards, as this may allow water to pass through the
steam tube onto the control area. Should this happen,
the kettle must be allowed to dry before re-using
• To avoid the risk of splashing,
once the kettle has
boiled wait 10 seconds then pour slowly.
Do not
over-tilt the kettle.
WARNINg: If THE kETTLE HAS jUST bOILED,
IT WILL bE fULL Of STEAm, WHICH WILL
ESCApE AS SOON AS THE LID IS OpENED.
• Do not switch the kettle on unless it contains at least
one cup of water. Misuse of this kind will shorten the
life of the kettle
• If the kettle is accidentally switched on when it does not
contain sufficient water, a boil-dry device will
automatically switch it off
• Wait until the kettle has cooled down before refilling.
The lid may be hot and the water may spit as it
touches the kettle base.
BOIL-DRY
If the kettle is accidentally switched on with no water inside, the boil-dry
device will switch off the heating element to prevent damage to the kettle.
4
4
CARE & CLEANING
Regular cleaning & care will keep your kettle looking newer for
longer and help prolong the life of the kettle.
• Switch the kettle off, lift it from the power base, unplug
the power base from the wall socket and LET ThE
KETTLE COOL DOWN COMPLETELY BEFORE
CLEANING. Wipe the outside and inside surfaces of
the kettle with a damp cloth
• If necessary, you may use a mild household detergent.
To clean the filter, see ‘water filter’ section below
• If you use detergent inside the kettle, rinse thoroughly
afterwards to remove all traces
• Ensure that all connectors and sockets are kept dry
• Do not immerse the kettle or power base in water or
any other liquid
• Do not use harsh or abrasive cleaners or solvents.
D
ES
CA
LE
R
PUSH THEN
PULL OUT
MINIMUM
1 CUP (250ml)
D
ES
CA
LE
R
PUSH THEN
PULL OUT
MINIMUM
1 CUP (250ml)
• Make sure hands are clean and free from hand cream,
soap or similar, which might leave a slight taint to the
water
• Remove the kettle from the power base and ensure
kettle is cold
• Open the lid. hold the top of the filter, pull up and
out of the kettle. Rinse under a tap while carefully
brushing it with a soft brush. Rinse the kettle out with
fresh water
• To replace, align the filter with the grooves in the filter
holder, insert and push back into place.
WATER FILTER
DO NOT OpERATE THE kETTLE UNLESS THE WATER
fILTER IS CORRECTLy IN pOSITION.
PUSH THEN
PULL OUT
PULL OUT
U
N
PL
U
G
WH
EN NO
T IN
U
SE
U
N
PL
U
G
WH
EN NO
T IN
U
SE
