Problem
Cause
Action
Unit will not turn on
(no power)
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage
Check connections for proper
voltage (11~16VDC)
Black wire not connected
Check connection to ground
Fuse blown
Replace fuse
Unit has power
(but no sound)
Speaker wires not connected
Check connections at speakers
One or more speaker wires touching each
other or touching chassis ground
Insulate all bare speaker wires from
each other and chassis ground
Unit blows fuses
Yellow or red wire touching chassis ground
Check for pinched wire
Speaker wires touching chassis ground
Check for pinched wire
Incorrect fuse rating
Use fuse with correct rating
Unit will not tune, seek or
autostore (AS/PS) stations
Unit has Manual Tuning Lockout feature
enabled
See your supervisor for the code
Excessive skipping
Unit is not mounted correctly or backstrap is
not secure
Check mounting sleeve and
backstrap support
Physical defect in media (CD, CD-R or CD-RW) Check media for scratches
ERROR 1 appears
on display
Disc read error
Press
EJECT
ERROR 2 appears
on display
Focus error or disc is in upside down
Press
EJECT
Unit will not accept
a disc
CD mechanism position out of alignment
Press and hold EJECT
for 3 seconds
to reset CD mechanism position
CD transit screws still in place
Remove 2 transit screws located on
top of the unit
Unit will not eject
a disc
Unit has Eject CD Lockout feature enabled
See your supervisor for the code
XD230M
OPERATION
Troubleshooting
10
CEA-2006 Power Standard Specifications
(reference: 14.4VDC +/- 0.2V, 20Hz~20kHz)
Power Output: 18 Watts RMS x 4 channels at 4 ohms and
<
1% THD+N
Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms)