3
Mounting
• After preparing dashboard as outlined on page 2, remove adhesive backing from foam
gasket and adhere gasket to dashboard. Dashboard must be clean and dry to ensure
proper adhesion.
• Open splashguard and detach side covers by pulling outward from the inside of side
cover.
• Insert supplied mounting bolts through washers and into mounting holes as shown
below. Secure bolts with supplied nuts.
• Install head unit into splashguard opening. This may vary depending on head unit
manufacturer and installation instructions. Refer to head unit owner’s manual for
details.
• Reattach side covers by aligning them and pushing into place until they snap on.
SG1/SG2
INSTALLATION
Mounting
HEAD UNIT
(not included)
MOUNTING SLEEVE
(not included)
MOUNTING BOLT
WASHER
SIDE COVER
SG1/SG2
SPLASHGUARD
GASKET
DASHBOARD
(not included)
NUT
