Dual Illuminite DSRE212 Скачать руководство пользователя страница 2

2

Installation

Thank you for purchasing the DSRE212 12” Twin Turbo Enclosed Subwoofers. Although 

Dual has attempted to make sure all of the information contained within this manual is 

accurate, please be aware that any part of it is subject to change without notice.

The following instructions should be used a general guideline only. 

If you are unsure about performing any of the procedures listed 

below, please consult a professional car audio installation center.

Before installation, please follow these guidelines:

1. Be sure to carefully read and understand the instructions before attempting to install 

this product.

2. For safety, disconnect the negative terminal from the battery prior to beginning the   

installation.

3. Use caution before you drill or cut! Be careful not to cut or drill into gas tanks, fuel 

lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any 

vehicle.

4. Never run wires underneath your vehicle. Running wires inside the vehicle provides 

the best protection from exhaust heat and environmental elements.

5. Avoid running wires over, near or through sharp edged surfaces. Use rubber 

grommets to protect any wires routed through metal.

6. When running cable from the amplifier, avoid running it near sources of high current 

(i.e. wiring harnesses, battery cables).

Power & Speaker Connections

Strip 5/8”

(16mm)

peaker Connections

+12VDC Battery Connection

1
2

Remote Turn On

Ground Connection

3

4

4

3

2

1

Strip 5/8”

(16mm)

16 AWG

12 AWG

(+

(+

(-)

(-)

O

n

O

ff

Optional toggle 
switch to turn 
LED lights on/off

Strip 5/8" off the end of the wires, and connect the DSRE212 to an amplifier as shown 
below for the speaker and illumination.

Отзывы: