Du Pont Cyrel FAST 2000TD, Руководство по эксплуатации

Страница: 87 / 106

Appendix A
A-1
Appendix A
Alarm list
Look up the alarm number and follow the instructions in the remedy description.
Alarm No Description Remedy
001 000 SW fault Please call an authorized Service Technician.
001 003 Front cover is open Close lower front cover.
001 004 Emergency stop activated Release emergency stop buttons.
001 005 Air pressure not ok Check air supply and pressure.
001 006 Front door is open Close upper front door.
001 007 Rear door is open Close rear door.
001 008 No configuration file Please call an authorized Service Technician.
001 009 Default configuration, calibration
needed. Please call an authorized Service Technician.
001 010 Configuration file not saved Please call an authorized Service Technician.
001 011 Job setup file not loaded Error on loading job file, please check if job
selection is valid.
001 012 Job setup file not saved Please call an authorized Service Technician.
001 013 Safety override switch activated Please call an authorized Service Technician.
001 014 Safety override switch activated. The
processor cannot be started Please call an authorized Service Technician.
001 015 Manual logging activated. The
processor cannot be started Please call an authorized Service Technician.
001 020 Main power rack failure 1 Please call an authorized Service Technician.
001 021 Main power rack failure 2 Please call an authorized Service Technician.
001 022 Main power rack phase failure Main power supply to machine phase error, check
power supply.
002 000 Arms, assert:{Please remove plate
from loading zone} Remove plate from loading zone/feeding table while
resetting machine.
Arms, assert:{Reset/Homing NOT
PIM_EMPTY} Machine not empty during homing of clamp arms,
empty machine before homing.
Arms, assert:{Process count start
OOR} Selected number of process count for starting plate
is not valid, check job.
002 002 Plate present at feed table when
machine is not ready to load Remove plate from loading zone/feeding table while
resetting machine.
002 003 Clamp arms, functional safety error Clamp arms too close to each other or another
moving element during operation, please check
before resetting machine.
January, 2020 Operation Manual | Cyrel FAST 2000TD