13
10.1-DMX Addresses
NICK NRG 1401 can be controlled with 33 DMX channels, 111 DMX channels or 20
DMX channels.
In order to use the unit in 33 DMX channels (default), set the following addresses on
the mixer:
Projector 1 A001
Projector 2 A034
If you want to select
the next projector, just add “33”
Projector 3 A067
…..
A….
projector 6
A166
10.2-Selecting the DMX address
1) Press the UP-DOWN key until you reach the required DMX channel. The numbers
on the display will start to flash (but the new DMX address hasn't yet been set).
2) Press ENTER to confirm your selection. The numbers on the display will stop
flashing and the projector is now setted to the new DMX address.
TRICKS:
If you keep pushed the UP or DOWN keys, the channels are calculated more quickly
and you get a faster selection.
11- FIRMWARE UPDATING
Attention:
This procedure require a base knowledge of computer applications.
Please refer to an authorised DTS service centre.
To update the software version of the NICK NRG 1401 you need:
- DTS RED BOX interface (DTS Code: 03.LA.008);
- USB-DMX Driver for the DTS RED BOX interface;
-
“DTS Firmware upgrade utility” program installed on your PC;
- Latest firmware available for NICK NRG 1401 unit.
Updating the software version.
Please follow the procedure below to perform the update:
1. Install the DTS RED BOX USB-DMX driver on the PC you will use to update the unit
software.
2. Connect the DTS RED BOX interface to the PC by using a USB cable.
3. Connect the DTS RED BOX interface to the fixture by using a DMX cable.
4. Load the new firmware into the unit by using
“DTS Firmware upgrade utility”
program.