DTS DRIVENET 28 EZ, Руководство пользователя

Страница: 15 / 28

15
11- DALI SIGNAL CONNECTION:
The unit operates using a digital DALI signal.
Connection between the controller and the unit or between units can be made by
using any standard cable minimum ø 0.5 mm.
Connect the mixer signal to the DALI 2-pole In/Out screw terminals panel connector
and re-send it to the next units.
In this way, all the units are cascade connected.
12- DALI FUNCTIONS
By using a DALI controller it is possible to set independently the value of the 8 output
channels only if DMX signal is disabled (DMX signal has priority on DALI signal).
Searching, addressing and report commands are accepted also if DMX signal is
enabled. DRIVENET 28 EZ accepts the following DALI commands:
Command Number Description
0 Off
1 Up (Fade Rate)
2 Down (Fade Rate)
3 Step Up (Increment Arc Power Level)
4 Step Down (Decrement Arc Power Level)
5 Recall Max Level
6 Recall Min Level
7 Step Down and Off (Decrement Arc Power Level if at min level turn Off)
8 On and Step Up (Increment Arc Power Level if off then turn On)
16...31 Go to Scene [0...15]
32 Reset (DALI factory default parameters)
33 Store Actual Level in the DTR
42 Store DTR as Max Level
43 Store DTR as Min Level
46 Store DTR as Fade Time
47 Store DTR as Fade Rate
64-79 Store DTR as Scene [0...15]
80-95 Remove from Scene [0...15]
96...111 Add to Group [0...15]
112...127 Remove from Group [0...15]
128 Store DTR as Short Address
144 Query Status
145 Query Ballast