2.4- Safety:
2.5- Level of protection against the penetration of solid and liquid matter
-The projector should always be installed with bolts, clamps and other fixtures that are
capable of supporting the weight of the unit.
-Always use a second safety chain of a suitable rating to sustain the weight of the unit in case
of the failure of the main fixing point.
-The external surface of the unit, at various points, may exceed 100°C. Never handle the unit
until at least 10 minutes have elapsed since the lamp was turned off.
-Always replace the lamp if any physical damage is evident.
-Never install the fixture in an enclosed area lacking sufficient air flow. The ambient
temperature should not exceed 35°C.
-A hot lamp may explode, so always wait for at least 10 minutes to elapse after the unit has
been turned off prior to attempting to replace the lamp.
Always wear suitable hand protection when handling the lamp.
-The projector is classified as an ordinary appliance and its level of protection against the
penetration of solid and liquid matter is IP 65.
The temperature inside the projector can reach 250° C after just 5 minutes, but it can get as
high as 350° C. Always check that the lamp is cold before attempting to remove it. In any
case, only open the appliance 10 minutes after it has been turned off.
1) Using a philips head screwdriver, remove the 3 screws placed on the rear end of the unit
so as to remove the lamp casing (photo 1).
2) Unscrew the three screws holding the lampsocket unit (photo2).
3) Remove the lampsocket unit and insert lamp in lampsocket (photo3).
3- MOUNTING THE LAMPS
WARNING: TURN POWER OFF BEFORE OPENING THE APPLIANCE.
Photo 1
Photo 2
Photo 3
5
www.bluelight.at
