3
1. Introduction
1.1General information
Electromechanical drive, designed to automate garage doors. The assembled and launched system
can be conveniently operated by radio transmitters (remote controls).
1.2. Technical dataGO801/1001
•
power supply:
230-240VAC 50/60Hz
•
nominal power:
235/245W
•
maximum gate movement speed:
180 mm / s
•
nominal traction force:
350N/400N
•
maximum pulling force:
800N / 1000N
•
temperature range:
-20 °C to + 40 °C
•
built-in lighting, lighting time:
permanent LED, 3min.
•
total length with head and handle:
3480 mm, 2x1.65m folding rail with toothed belt
•
maximum stroke of the trolley:
2820mm
•
maximum door width:
5000 mm
•
maximum door area:
12.6 m2
•
Ingress ProtectionCode:
IP-20
1.3 Mechanical components
Before starting work, make sure you have all the elements shown in Figure 1, and then read the entire
manual.
2. MECHANICALASSEMBLY
2.1. Verification of the type and structure of the gate
In order to properly complete and install the automation system, verify the type of your gate and check
the structure of the existing or installed gate in terms of the requirements presented below:
•
The basic set enables the automation of sectional gates with an ordinary running rail - it is recommended
to use a "boomerang" type handle, with a double running rail - without a "boomerang", overhead gates -
without a "boomerang" and side gates, fig.2;
•
The structural elements of the gate must meet the requirements of EN 12604;
T
echnical data / Introduction
Fig. 1.
Set of mechanical elements.
4xM6
2x
5
1
3
9
6
7
10
8
2a
2b
4
Part definition:
1 drive head with lighting;
2a 1.65m rail with a toothed drive belt;
2b 1.65m rail;
3 coupler;
4 carriage and emergency release locking mechanism;
5 ceiling hanger;
6 pin and securing pin, bolt and tension spring;
7 front piece;
8 tension element;
9 cart-gate pusher;
10 gate hardware;
