background image

Section 4: Place the Tray on the Applicator Platform

1.   The tray has pins on the bottom that correspond to holes on the movable Container Guide attached to the AP550e 

Container Platform.  Place the tray on the platform so the pins drop into the corresponding holes.

2.   If the container does not sit square to the platform (labels will be applied crooked), adjust the angle of the tray.  Loosen the 

thumb screw.  Adjust the angle as needed.  Retighten the thumb screw.  You may also adjust the side-to-side position of 

the tray by following the instructions for adjusting the Container Guides in Section 3 of the AP550e Operator’s Guide.

Congratulations! You are now ready to label your containers.

Mode

Thumb Screw

Pins

Molding 

compound and 

container not 

shown to reveal 

tray detail.

Holes

Содержание 74398

Страница 1: ...Container Holder Kit for use with the AP550e Label Applicator Instruction Manual 2019 All rights reserved For the most recent version of this manual please visit dtm print eu ...

Страница 2: ...are the Container To account for shrinkage of the molding compound and for subtle variations from container to container you must put a layer of the included UHMW Tape over the portion of the container that will come in contact with the molding compound This tape also allows the container to easily release from the molding compound Apply the tape to the container without overlapping the tape It ma...

Страница 3: ... the UHMW tape covered container tape side down in the molding compound Note the orientation of the labels coming off the roll and position your container accordingly 3 Firmly press down on your container so that it becomes imbedded in the mold Align the container so that it is parallel with the tray edges 4 The molding compound may push away from the container when you press it down While holding...

Страница 4: ...s not sit square to the platform labels will be applied crooked adjust the angle of the tray Loosen the thumb screw Adjust the angle as needed Retighten the thumb screw You may also adjust the side to side position of the tray by following the instructions for adjusting the Container Guides in Section 3 of the AP550e Operator s Guide Congratulations You are now ready to label your containers Mode ...

Отзывы: