DTI GmbH & Co. KG
MAIN MENU
1 SAVE PROGRAM
( 1-25 )
: 01
2 LOAD PROGRAM
( 1-25 )
: 01
3 SEARCH GAIN
( 1-8 )
: 01
4 SEARCH MODE
( 0-3 )
: 04
5 PULSPOWER
( 1-10 )
: 01
6 PIU GAIN
( 0-3 )
: 00
7 SEARCH MEMORY
( 1-32 )
: 11
8 GRAPHIC MODE
( 1-4 )
: 01
9 PROGRAM INFO
-----
CHANGE
1. SAVE PROGRAM
Below this menue you can store up to 25 programs. The chosen parameters will be
stored below the chosen program number and remain being stored when the detector
is switched off.
2. LOAD PROGRAM: Below this menue you can activate the stored program.
3. SEARCH GAIN: This paramter is identical to the active parameter and can be
changed here.
4. SEARCH MODE: Behind this there are 5 filterlevels hidden. As low the filterlevel the
searching speed will be high but also the sensitivity to the interferences will increase.
Here you have to make decision on the searching area. In connection with the known
Suchmodes will be made very high searching speeds.
5. PULSEPOWER- Below this parameter you can change the puls power.
6. PIU GAIN: You can increase the origin signal in following levels: 0:unchanged;
1:doubly: 2:fourfold; 3:eightfold. Please notice that in connection with the Suchmodus
and the other known amplify parameter have to make decision on the searching area.
You have already by the start with the 28 cm coil minimum one cubic meter ground
under. By the to much increasing the detector react maximum detection by every
moving over the ground also no object exist. The summery of the ground mineraliza-
tion and the moving of the coil in the earth magnetic field produce a strong signal.
High amplification needs always a high Suchmodus and small search speed.
7. SEARCH MEMORY- This paramter is identical to the active parameter and can be
changed here.
8. GRAPHIC MODE - At this menue you can change the active display. The less
komponents the faster the display speed.
1. Number Display, Bar graphic, Spectrum and Detector Display
2. Number Display, Bar graphic, and Detector Display
3. Number Display, Bar graphic, and Spectrum
4. Number Display and Bar graphic
9. PROGRAM INFO – Program Info allows viewing the program memories.
Page 18 of 30
