DTI Dyna Technology Winco W3000H, Инструкция по установке и эксплуатации

Страница: 5 / 12

5
1203-00 60706-220
Self-exiting generators respond to severe overload-
ing differently than utility power. When overloaded,
the engine is not able to supply enough power to
bring the electric motor up to operating speed. the
generator responds with high initial starting current,
but the engine speed drops sharply. The overload
may stall the engine. If allowed to operate at very
low speeds, the electric motor starting winding will
burn out in a short time. The generator winding
might also be damaged.
CAUTION: EQUIPMENT DAMAGE
RUNNING THE GENERATOR SET UNDER
THESE CONDITIONS MAY RESULT IN DAMAGING
THE GENERATOR STATOR AS WELL AS THE MO-
TOR WINDING.
Because the heavy surge of current required for
starting motors is required for only an instant, the
generator will not be damaged if it can bring the
motor up to speed in a few seconds of time. If dif-
fi culty is experienced in starting motors, turn all other
electrical loads off and if possible reduce the load on
the electric motor.
PREPARING THE UNIT
UNPACKING
CAUTION: EQUIPMENT DAMAGE
THIS UNIT HAS BEEN SHIPPED WITHOUT OIL.
Failure to maintain the engine oil at the proper level
will result in serious engine damage.
When you unpack your new engine-generator set be
sure to remove all the information sheets and manu-
als from the carton.
1. This generator-set was in good order when
shipped. Inspect the generator-set promply after
receiving it. If any damage is noted, notify the trans-
portion company immediately; request proper pro-
cedures for fi ling a “concealed damage” claim. Title
to the equipment and responsibility for fi ling a claim
rests with you when a generator-set is sent F.O.B.
shipping point. Only you can legally fi le a claim.
2. Before proceeding with the prepartions of your
new generator-set for operation, take a couple of
minutes to insure the unit you have received is the
correct model and review the specifi cation pages in
this manual to insure that this unit meets your job
requirements.
UNIT PREPARATION
Before your generator-set was shipped from our
factory it was fully checked for performance. The
generator was load tested to its full capacity, and the
voltage and frequency were carefully checked and
adjusted.
LUBRICATION
Before starting the engine, fi ll the crankcase to the
proper level with a good quality oil. The recom-
mended grade of oil and quantity of oil required is
listed in the engine operator’s manual. The neces-
sity of using the correct oil, and keeping the crank-
case full cannot be overemphasized. Engine failures
resulting from inadequate or improper lubriant are
considered abuse and not coverd by the the genera-
tor or engine manufacture’s warranty.
GASOLINE
When using gasoline always use a good grade of
unleaded fuel. This engine is certifi ed to operate on
unleaded gasoline with a pump octane rating of 86
or higher. Gasoline containing no more than 10%
ethanol (E10) or 5% methonal by volume may be
used. In addition methanol must contain cosolvents
and corrosion inhibitors. Use of fuels with content
of ethanol or methanol greater than shown above
may cause starting and/or performance problems.
Always insure that the fuel is clean and free of all
impurities.
WARNING: FIRE DANGER
Gasoline and its fumes are VERY explosive when
proper precautions are not taken.
Never use gasoline that has been stored for an ex-
tended period of time as the fuel will lose it’s volatile
properties and you will be left with only the varnish
residue. The varnish like substance will clog the
carburetor and will not burn properly.
The use of fuel additives, such as STA-BIL, or an
equivalent will minimize the formation of fuel gum
deposits. If a a unit has been out of operation for
an extended period of time it is best to drain old fuel
from the engine and replace with fresh fuel before
attempting to start.
OIL ALERT SYSTEM
The Oil Alert system is designed to prevent engine
damage causes by insuffi cient amount of oil in the
crankcase. Before the oil level in the crankcase can
fall below a safe limit, the Oil Alert system will auto-
matically stop the engine.