Revision 19.1
SOLO7 Transmitter User Guide
Copyright © 2013 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 5-33
5.8.4
Service Options
Name
Options
Notes
Manual mux bitrate
Auto/manual
When set to 0 the mux bit rate is defined automatically based
on modulation settings.
When set manually with RF output turned off. This overrides
the automatic calculation. In this case it can be used to
adjust the stream rate on the ASI outputs.
Network name
Default: DTC
The Network Name applies to the transport stream (TS).
Inside that TS there may be many Services each with a
Service Name.
Click in the box to edit.
Service name
Default: Solo-01
This is an identifier for the service within the transport
stream (TS). This must match the name at the receiver for
the service to be decoded.
Click in the box to edit.
Program number
1 to 16
The Program Number uniquely identifies the channel in a
transport stream. All channels in a chained system must
have a different Program Number which can be decoded at
the receiver.
Click in the box to edit.
PIDs
32 to 8190
The packet ID numbers are automatically allocated,
according to the Program number.
The PIDs can be edited but should be left to default unless
an advanced user.
