2. Operating Instructions
Using the UHF Wireless Microphone
1. Open the battery compartment of wireless hand-held mic or belt-pack transmitter mic
and insert supplied 2 x AA type batteries in their c/- polarity.
2. Set Ch-number of amplifier and microphone both to same number by Ch-selector
switch using supplied plastic “I” screw driver. ( Please see the schematic below )
3. Clockwise insert the supplied BNC wireless antenna into it’s socket on the operating panel.
4. Plug your wired microphone into the combination jack on the operating panel.
5. Turn on the main power on/off switch. Power-on LED will be illuminated.
6. Adjust the volume level of wired mic and try while setting treble/bass to proper level.
7. Adjust the volume level of wireless mic on the amplifier. Turn on the switch of wireless
mic and try. The on-air LED next to the Ch-selector switch will be illuminated.
8. In the case of frequency interference occurring, try to set Ch to another Ch-number.
9. Use the aux in/out RCA jack to feed out or feed in audio signals to and from another source.
Using the Wired Microphone
1. Turn on the main power on/off switch, the power-on LED will be illuminated
2. Plug 1/4” plug into the wired mic socket and adjust the volume using the wired mic volume knob.
(see number 6 and 9) on the operating panel.
NOTE:
Wired microphones are also as sensitive to feedback as wireless microphones, therefore it is advisable to follow the same advice as in the
above information for optimum performance
Using Auxiliary Equipment
1. Use the Aux in/out jack connection to feed in or out audio signals from another source
2. Typical sources to feed into the amplifier are MP3 players, DVD players, laptops and palm devices
etc. where you want to amplify the sound to larger audiences.
3. The feed out socket can be used to connect to amplifiers and mixers.
Connecting the DVD
Connecting the DVD to the TV
How to Operate the Pitch - Control led DVD/USB/SD - Card Player
Function Setup
(The default setting will be left unchanged by power on or off)
Press [SETUP] when a disc is not running --- SETUP menu appears ---
Press ◄ ► to select menu
Press ▲▼ to select sub-menu
Press ◄ ► to choose proper language on each sub-menu (Set DEFAULTS as “OFF” to
maintain your setup)
Press [ENTER] to save your setup
Press [SETUP] to exit
Wide range of playable discs
DVD, SVCD, VCD, MP3CD, CD-RW, CD
Utility Video output by RCA Jack, AUX Jack
Perfectly shock proofed sturdy mechanism in addition to 40 sec ESP
Beware to shut off all power before connection.
Connect Video Output (RCA Jack: Yellow) to Video-in of TV by supplied RCA cable.
Please note: Only the Yellow plug on the cable needs to be connected
Supplied plastic screwdriver
Amplifier
Belt-pack Hand-held mic
LCD TV (monitor)
TV
VIDEO-IN
VIDEO-OUT
TV
Please keep the
Volume(Gain)
as factory-set
Using the DVD Player
Front Panel
Safety Precautions
There are dangerous voltages inside this product. To prevent electric shock do not open the cabinet yourself. For service
please contact our regional representative office or direct to us as per the instructions of Limited Warranty
1. Power on-off switch
2. Mode select
3. Play/Pause button
4. Mute on/off
5. SYS(P/N) PAL/NTSC change button
7. INT
11. STOP
14. RPT
16. ZOOM
18. RDM
20. Fast / Next chapter / track
22. On-Screen display
1
20
Disc Slot
16
2
5 3 7 14 18 22 11 4
SD-Card
Port
USB Port
Ejects Disc
