button (the number diminishing, LED numeric display 029’028…’025), LED numeric display OFF and
setting finish.
LUX and SENS adjustment
1. use flat-head screwdriver to turn the knob, note: to avoiding destroy the knob, you should turn it lightly
but not overexert ;
2
．
SENS adjustment: by turning the SENS knob to adjust the detecting distance; turn clockwise to
increase sensitivity and counterclockwise turn to decrease it.
3
．
LUX adjustment: turn clockwise to increase working light and when turn to the end(?)the unit can
work all day and all night; counterclockwise turn to decrease it, when turn to the end(?), it only can work
in the circumstance <3LUX; you can turn the knob to other position according to your required working
light.
Normal mode:
LED numeric display OFF. Sense, the load work for some time, time-delay is adjustable,
default is 8sec.
1. slide switch to normal mode and the unit be in normal mode;
2. turn light control(LUX) knob to ?
（
max
）
and sensitivity knob(SENS) to certain position;
3. Switch on power, the load doesn’t work and LED numeric display reversing 50~00. when LED
numeric display OFF, the sensor enter working state;
4. moving in the sensing range, the LED numeric display “-“ moving to left, that indicate the sense
signal is detected,
5. after receiving sense signal, the sense LED lights and the load works, keep human body hold
still absolutely, under no continual sensing condition, the LED numeric display reversing
time-delay (example: default 8sec, and it display reversing like 008…000) until the LED numeric
display OFF, the load stops working;
6. like that, sense once, the load works for 8sec(you can set other time-delay).
Note: after sense it for the first, it receive sense signal again, the time delay will
recompute time from the second sense
，
so when human body always move in the sense
range, the load will work always.
7. using remote controller:
press on key
：
make the load work always;
press off key
：
1
）
make the load stop working;
2
）
after convert to impulse mode, press the key to return normal mode;
press impulse key
：
convert to impulse mode, note: after switching off, the unit return normal
