DSR PSC-12500A, Руководство пользователя

Страница: 22 / 64

•
17
•
PROBLEM POSSIBLE CAUSE REASON/SOLUTION
The DIGITAL DISPLAY
always flashes before
the battery is completely
charged.
The incorrect BATTERY
TYPE may have been
selected.
The battery did not reach
full charge within 24 hours.
The battery is defective.
Reset the charger by briefly
unplugging it or briefly
disconnecting the negative
battery clip. Be sure to reset
the charger to the proper
settings.
May be due to a very large
battery or bank of batteries
requiring more power than
the charger can deliver
within 24 hours.
Have the battery checked.
The CHARGED (green)
LED lights a few minutes
after connecting to the
battery.
The battery may be
fully charged or recently
charged, leaving the bat-
tery voltage high enough to
appear to be fully charged.
The incorrect BATTERY
TYPE may have been
selected.
If the battery is in a vehicle,
turn the headlights on for
a few minutes to reduce
the battery voltage and try
charging again.
Reset the charger by briefly
unplugging it or briefly
disconnecting the negative
battery clip. Be sure to reset
the charger to the proper
settings.
The indicator lights are lit
in an erratic manner not
explained in this manual.
You might have acciden-
tally activated a special
diagnostic mode.
Make sure nothing is touch-
ing the control panel, then
unplug the charger and plug
it in again.
BEFORE RETURNING FOR REPAIRS 17.
When a charging problem arises, make certain that the battery is capable 17.1
of accepting a normal charge. Use a good battery to double check all
connections, AC outlet for a full 120-volts, charger clips for correct polarity
and the quality of the connections from the cables to the clips and from the
clips to the battery system. The clips must be clean.
When a battery is very cold, partially charged or sulfated, it will not draw
17.2
the full rated amperes from the charger. It is both dangerous and damag-
ing to a battery to force higher amperage into it than it can effectively use
in recharging.
When an UNKNOWN OPERATING PROBLEM arises, please read the
17.3
complete manual and call the customer service number for information
that will usually eliminate the need for return.
If the above solutions do not eliminate the problem or for information about troubleshooting
or replacement parts, call toll-free from anywhere in the U.S.A.
1-800-621-5485
7:00 am to 5:00 pm Central Time Monday thru Friday