DSPPA MAG6182II, Руководство пользователя

Страница: 20 / 76

* *
Network Address System
Network Public Address System Network Public Address System 15
2.6 Stand-by module for power extension
CH3(2A)
Power Slave
CH4
(2A)
-220V / 50Hz / 10A
INPUT
Setup
CH2(2A) CH1(2A)
Net
12
V-4
SC
-4
C
O
M
12
V-3
SC
-3
C
O
M
SC
-2
12
V-2
SC
-1
12
V-1
Setup
Power OUTLET -220V
/50Hz/8A
1. Setup indicator
When the parameters of this module cannot be found, such as IP is not clear, pull down the Mode key and this
indicator will be on.
2. Power sequence input socket
The power supply of this card is AC220V (±10%), please ensure that the power supply voltage input to the
machine is consistent with the power supply voltage of the machine.
3. 12V power output interface/short-circuit signal output interface
12V - 1...12V-4, channel 1 to 4 channel 12V power supply output, COM is the common end, the output signal of
this interface is controlled by the host, each channel control corresponds to the corresponding host power control.
SC - 1...SC-4, channel 1 to channel 4 short circuit signal output, COM is the common end, the output signal of
this interface is controlled by the host, each channel control corresponds to the corresponding host power control.
4. DIP switch
When the parameters of this module cannot be found, such as IP is not clear, pull down one of the four dial keys,
the indicator will be on, and the local parameters will recover the following specific parameters:
IP
：
192.168.61.2 GATE
：
192.168.61.1
Mask Code
：
255.255.255.0
Main server IP
：
192.168.61.250 Standby server IP
：
192.168.61.251
After setting, pull back to mode will restore the former configuration.
Note: only one machine of the same type can be set to mode in the same network at a time, otherwise IP
conflicts will occur.
Note: pull down any of the DIP switch will enter the default IP parameter setting. This mode is generally
used to modify the IP parameters. After the modification, the default IP indicator will flash. Pull back the
1 2 3 4 5 6