A
NTI
-M
ODE
TM
X2
U
SER
’
S
G
UIDE
4.Firmware update
The firmware of Anti-Mode
TM
X2 is updated using a USB memory stick.
•
Download the firmware file ( FIRMWARE.X2 ) and copy it to the USB memory stick into its root
directory. Make sure the USB memory is using the FAT filesystem format. Some sticks are
formatted with the exFAT filesystem, which is not supported.
•
Put the Anti-Mode X2 unit to standby with
a
.
•
Attach the USB stick to the "SERVICE" USB port on the rear panel of the X2.
•
Turn on the Anti-Mode X2 with
a
and wait until the system automatically installs the firmware.
Alternatively, switch off and then on by disconnecting and connecting the power plug.
•
Do not remove the USB stick during the update process. After finishing installation the system
reboots, and the home screen is displayed. Now the USB stick can be removed.
The firmware is not updated if the unit already contains the same version of the firmware. In this case,
after checking the contents of the USB stick the unit will start normally.
If you encounter any problems during the update, make sure the USB stick is properly connected and
contains the firmware file. If the problem persists, try copying the firmware file again on a different USB
memory stick. Make sure the USB memory is using the FAT filesystem format.
Some USB memory sticks may not be compatible with the firmware update.
5.Manufacturer
VLSI Solution /
DSP
eaker
Hermiankatu 8
FIN-33720 Tampere
FINLAND
Email: [email protected]
Contact
Rev. 1.1
2022-08-10
Page 11 (12)
Содержание Anti-Mode X2
Страница 1: ...Anti ModeTM X2 User s Guide ...
