Document:
SD-E4HDU 1M5
Document:
SD-E4HDU 1M5
Document:
SD-E4HDU 1M5
Page:
3
Page:
3
OWNER'S MANUAL
SD-E4HDU mini PTZ camera AHD
DSE srl - Digital Surveillance Equipment - WWW.DSE.EU
FUNCTION
PRESET
FURTHER INFORMATION
Set address
September 85
CALL 60 CALL
N
N = address of the camera on the RS485 BUS (1..256)
Set baud rate
SET 85 61
CALL CALL N
2400 baud N = 1 N = 2 N =
3 4800 baud 9600 baud
Set video output
September 85
CALL 62 CALL
N
N = 1 N = 2 AHD AHD PAL
NTSC PAL CVBS N = 3 N =
4 CVBS NTSC
Check that the video management device (DVR) supports the new format before performing the switching because otherwise you
will not be able to control the camera. Be careful in this change.
Home Function
September 85
CALL 75 CALL
N
It sets the automatic function in which the camera automatically returns after a certain time of inactivity. N = 1 N = No HOME
position Preset 1 2 N = 3 N = 4 1 Autoscan Tour 1 N = 5 Pattern 1
Tempo Home
September 85
CALL 76 CALL
N
It sets the idle time after which the camera returns to the home set above function. N = 1..60 minutes
IR illuminators Control
September 85
CALL 70 CALL
N
It sets the power mode of IR illuminators. N = 1 Automatic ignition N = 2 N = 3 Always on
Always off
illuminators with zoom power to a
minimum (close)
September 85
CALL 71 CALL
N
N = 1..10
illuminators Power Zoom maximum
(away)
SET 85 72
CALL CALL N
N = 1..10
Ignition Sensitivity IR illuminators
September 85
CALL 73 CALL
N
Defines the threshold power of the illuminators N = 1..10 (a lower value corresponds ignition with less brightness)
left scan limit
September 92
As linear SCAN defines the horizontal continuous movement of the camera between two end points with the same
level of TILT. With this preset you set the left limit of the scan
Right scan limit
September 93
With this preset you set the right limit of scan
speed scan
September 85
CALL 77 CALL
N
It defines the speed of horizontal scanning N = 1..50
Start scan
CALL 99
With this preset starts the horizontal scan
Stop scan
CALL 96
With this preset stops the horizontal scanning
Preset Home Tour
September 85
CALL 50 CALL
N
As TOUR or CRUISE means the sequential display of more preset with a certain residence time on each one. Of the camera
factory performs the tour between preset from 1 to 10 with a residence time on each preset to 10 seconds. Here you can set a
different preset start from preset 1 N = Preset start tour
Preset final tour
SET 85 51
CALL CALL N
Here you can set the preset end of the tour (Factory 10) N = Preset end tour
Residence time of the tour
September 85
CALL 52 CALL
N
Here you can set the dwell time of each preset during the tour (10 seconds Factory) N = 1..255 seconds
Start tour
CALL 98
With this preset you start the tour
