2
The power plug has to be accessible after installing the fixture. Do not
overload wall outlets and extension cords as this can result in fire or electric
shock.
DO NOT
allow anything to rest on the power cord.
DO NOT
locate this
fixture where the cord may be damaged by persons walking on it.
Make sure that the power cord is never crimped or damaged by sharp
edges. Check the fixture and the power cord from time to time.
Refer servicing to qualified service personnel.
This fixture falls under protection class I. Therefore this fixture has to
be connected to a mains socket outlet with a protective earthing
connection.
DO NOT
connect this fixture to a dimmer pack.
LED light emission. Risk of eye injury. DO NOT look into the beam at a
distance of less than 1 meter from the front surface of the product. Do
not view the light output with optical instruments or any device that
may concentrate the beam.
If the fixture has been exposed to drastic temperature fluctuation (e.g.
after transportation),
DO NOT
switch it on immediately. The arising
condensation water might damage your device. Leave the device switched
off until it has reached room temperature.
DO NOT
shake the fixture. Avoid brute force when installing or operating
the fixture.
This fixture was designed for indoor use only, do not expose this unit to
rain or use near water.
When choosing the installation spot, please make sure that the fixture is
not exposed to extreme heat, moisture or dust.
Do not block the LEDs array with any object when the fixture is under
operation
The openings should never be covered with cloth or other materials, and
never must be blocked. This fixture should not be placed in a built-in
installation unless proper ventilation is provided.
Only operate the fixture after having checked that the housing is firmly
closed and all screws are tightly fastened. Always use a secondary safety
cable when mounting this fixture.
Make sure that the area below the installation place is blocked when
rigging or servicing the fixture.
DO NOT
block the front objective LEDs with
any object when the fixture is under operation.
