©2017 Tyco Security Products, Toronto, Canada www.dsc.com Tech. Support: 1-800-387-3630
Metal Enclosure
• Model PC5003C (removable door) made of 22Ga steel, painted, dimensions: 248mm(L) x 298mm(W)
x 76mm(H), weight: 1500g.
Figure 2 Battery and AC W ire Routing
LIMITED WARRANTY
Digital Security Controls warrants that for a period of twelve months from the date of purchase, the
product shall be free of defects in materials and workmanship under normal use and that in fulfilment
of any breach of such warranty, Digital Security Controls shall, at its option, repair or replace the
defective equipment upon return of the equipment to its factory. This warranty applies only to defects
in parts and workmanship and not to damage incurred in shipping or handling, or damage due to causes
beyond the control of Digital Security Conrols such as lightning, excessive voltage, mechanical shock,
water damage, or damage arising out of abuse, alteration or improper application of the equipment.
The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and
all other warranties, whether expressed or implied and of all other obligations or liabilities on the part
of Digital Security Controls. This warranty contains the entire warranty. Digital Security Controls
neither assumes responsibility for, nor authorizes any other person purporting to act on its behalf to
modify or to change this warranty, nor to assume for it any other warranty or liability concerning this
product. In no event shall Digital Security Controls be liable for any direct or indirect or con-
sequential damages, loss of anticipated profits, loss of time or any other losses incurred by the buyer
in connection with the purchase, installation or operation or failure of this product.
Warning: Digital Security Controls recommends that the entire system be completely tested on a reg-
ular basis. However, despite frequent testing, and due to, but not limited to, criminal tampering or
electrical disruption, it is possible for this product to fail to perform as expected.
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by Digital Security Controls could void
your authority to use this equipment.
This equipment generates and uses radio frequency energy and if not installed and used properly, in
strict accordance with the manufacturer’s instructions, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for Class B device in accord-
ance with the specifications in Subpart “B” of Part 15 of FCCRules, which are designed to provide
reasonable protection against such interference in any residential installation. How¬ever, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
inter¬ference to television or radio reception, which can be determined by turning the equipment off
and on, the user isencouraged to try to correct the interference by one or more of the following meas-
ures:
• Re-orient the receiving antenna
• Relocate the alarm control with respect to the receiver
• Move the alarm control away from the receiver
• Connect the alarm control into a different outlet so that alarm control and receiver are on different
circuits. If necessary, the user should consult the dealer or an experienced radio/television technician
for additional suggestions. The user may find the following booklet prepared by the FCC useful: “How
to Identify and Resolve Radio/Television Interference Problems”. This booklet is available from the
U.S. Government Printing Office, Washington D.C. 20402,Stock # 004-000-00345-4.
