DSC PC5400, Руководство по установке

Страница: 3 / 26

3
Introduction
Installation
Mounting the Cabinet
When mounting a new cabinet for the PC5400,
select a dry location near the F1/F2 subset for
DVACS communications.
To mount the PC5400:
1. Press the four white circuit board stand-offs
into the raised mounting holes from the back
of the cabinet.
2. Hold the cabinet in position and pull the wires
into the cabinet.
3. Mount the cabinet securely to the wall using
the mounting screws provided. Use the
appropriate wall anchors when securing the
panel to the drywall, plaster, concrete, brick or
other similar surfaces.
4. With the cabinet mounted press the PC5400
module into the stand-offs.
Wiring
Refer to the Hook-up Diagram included in this
manual.
RED, BLK, YEL and GRN Terminals
Connect the RED, BLK, YEL and GRN terminals to
the RED, BLK, YEL and GRN terminals on the
control panel. Refer to the control panel
Installation Manual for complete instructions on
keybus wiring.
T1 and T2
Connect T1 and T2 to a normally closed switch
that will be used to monitor tampers. If no tamper
switch is desired place a wire between T1 and T2.
Features
Allows compatible alarm control panels to be
connected to a DVACS communications network.
Module Specifications
• 4 wire (QUAD) hook-up to keybus
• Normal current draw of 35mA
• Tamper and Trouble reporting codes
• Maximum cable length: 61m (200 ft)
PC5400 connected to a DVACS network
• Automatic programming for DVACS
reporting codes.
• Monitoring for DVACS line fault.
• Module self diagnostics.
Compatible Panels
• PC5015
• PC5010
• PC5008
• PC1575
• PC1555
• PC580